1026r curl function backflow

[swick1]

When I have to curl with my pallet forks on unless I move the valve all the way open very fast I get backflow through the circuit and the forks drop a couple of inches before curling back properly. Is there an easy fix to this problem? It makes bulky items scary to lift.

[scrappy isb67]

sounds like the load check valve isn't working.

[swick1]

Where would this valve be located? Before the valve block?

[s219]

I think this is a known issue with the 1-series -- talk to your dealer about it. There is a fix they can apply.

[HunterWare]

I had the same problem. The dealer replaced the SCV and everything worked properly after that.

[swick1]

Thanks. I'll visit them tomorrow and let you know what they say!

[J_J]

The load check valve is usually in between the work ports.

Remove and inspect, clean, or replace.

[swick1]

They say the dropping is normal and all the 2000psi tractors do it

[s219]

Don't buy that -- they are selling you a line of BS. It should not do that.