montgmery ward wood splitter hydraulic pump made by John S Barnes YF 717-0461

[fredshop2]

I would like to know the spec s of the pump and if any ones knows where to pick up a replacement

[murphy1244]

Welcome to TBN

[The kid]

Welcome to TractorByNet

[mguitas]

[J_J]

Are you looking for parts?

Do you want to replace that pump with something equal?

What is the HP of the engine driving the pump?

Can you show a picture?

Would you need a two stage log splitter pump to match your engine?

[fredshop2]

the engine is a 8 hp briggs and stratton I wanted to find a pump comparable I sent the pump no. some body out there may know the spec.s then i can try and locate a pump out there . any heelp would be apreciated skip

[J_J]

Here is a pump for your engine.

http://www.surpluscenter.com/item.as...name=hydraulic

Depending on your log splitter cyl, the cycle time should be pretty fast.

[oldnslo]

John S. Barnes was purchased by the Haldex corporation several years ago and now recently someone purchased them from Haldex so I suspect information on that pump may be hard to get.

I would check the front mounting features and drive shaft size and then find a pump like J_J references with these same features.

[J_J]

If the pump above will not fit your pump mount, then select a pump mount from this list, observing the bolt hole pattern.

Most 8 HP engines are 1 in shaft.

You might need to change out the couplings. Lovejoy type, etc.

[Leejohn]

oldnslo, Is John S Barnes on the river my state st, or is that W.F. & John Barnes?