Fishman1227
New member
I have a 1710 Ford Tractor. I want to know, can I add a remote Hydraulics for the rear of this tractor? It has already a front end loader on it now..
Thanks
Thanks
1710 Ford Tractor!!
- Thread starter Fishman1227
- Start date
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,928
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
If you have hyd on it now, is it easy enough to add to the hyd system.
Tractor Data says you have a total pump flow of 7.8 GPM.
Is this a new type loader valve, with a PB port, and if so, you can add a remote valve.
Tractor Data says you have a total pump flow of 7.8 GPM.
Is this a new type loader valve, with a PB port, and if so, you can add a remote valve.
OP
Fishman1227
New member
Ok, I'm not sure about that. What is a PB port??
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,928
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
If you have a loader valve with PB, you will have seven hoses.
You may have the PB port and not using it.
Look on your valve and see if there is a stamped PB by one of the ports.
PB is used to pass fluid to the next valve.
Valves with out PB use the return port to pass fluid to a tank/reservoir.
You may have the PB port and not using it.
Look on your valve and see if there is a stamped PB by one of the ports.
PB is used to pass fluid to the next valve.
Valves with out PB use the return port to pass fluid to a tank/reservoir.
OP
Fishman1227
New member
Ok I will go look!! We just got done with a 13" snow.. so it will be a bit before I post back!!
OP
Fishman1227
New member
It has 4 coming from the side and 2 from the bottom with a fill line from the trans. Looks like you could add one more if need be, but I'm not sure.
georgiaplowboy
New member
I have a 1710 ford tractor with 3 lines coming from the transmission to the control valve for the front loader.Can I hook into 2 of these lines for a 3 point hitch backhoe?If so which lines do I hook into?