Processor

   / Processor
  • Thread Starter
#21  
The drive is a 345cu in international industrial engine with a twin disc clutch and four to one reducer to the output shaft. That why it runs at 300 rpm with the engine running 1200 rpm. Lots of torque and slow on the he engine.
 
   / Processor
  • Thread Starter
#22  
The pump doesn’t have any markings on it but it has four banks on it. It came off of a Lafont firewood processor that I figure was mid eighties. It has two 1 1/4” outlets one 1” and one3/4” outlet.
I have one 1 1/4” feeding the hotsaw one feeding the splitter and the 1” feeding saw arm wedge adjuster feed and hold down etc.
 
 
Top