Results 11 to 11 of 11
07-09-2012, 09:24 PM #11
Re: TX2140 with FEL 80w Gear Oil or UTF hydraulic (Tx2160,g154,tx1500,tx1300)
I've decided against the Renew type of oil, Softens seals scares me.
I'm going with a UTF.
They are about the same viscosity as 80W and are designed for Hydraulic systems.
Here's my logic.
If you believe the primary use of your tractor fluid is a
gear oil "for hypoid gears" going 90MPH down the high way
the I suggest sticking with rated SAE, API ....80-90 GL-5 or similar.
They are perfectly good Gear oils. Any of it will work fine
and I'm sure they are all Superior to the
strait 80W fluid the OEM ( Iseki)
installed and spec in there 1980 literature.
If you believe the primary use of use of your tractors fluid is
to run your hydraulics (FEL) at reasonable lift and lower times
without excessive foaming and run the FEL at colder temps.
And never get you tractor over 10MPH.
I suggest a fluid designed for Hydraulic and Gear use in Tractors
something labled Trans/Hydraulic Fluid.
IE:Travellerｮ Universal Tractor Trans/Hydraulic Fluid
I've listed all the fluids Hydraulic, Gear. UTF available at TS
and there Viscosity (SUS @ 100 F)
Notice the UTF viscosity at 100 F is right at in the middle of 80W.
Good chart on viscosity can be found at
Travellerｮ Ford Tractor All Mineral 90 Transmission Fluid
ISO Viscosity Grade: 150
Viscosity (SUS @ 100 F): 750
Flash Point: 455 deg. F
Pour Point: 0 deg. F
80 gear oil
Couldn't find any at TS
Viscosity (SUS @ 100 F): 350-450
Xtremeｮ Tractor Hydraulic & Transmission Fluid
Use where mid-viscosity range hydraulic fluid is required.
It is recommended for use in warmer climates
Travellerｮ Universal Tractor Trans/Hydraulic Fluid
ISO Viscosity Grade: Multi-Viscosity
Viscosity (SUS @ 100 F): 400
Flash Point: 435 deg. F
Pour Point: -44 deg. F
Wlamart Super Tech Heavy Duty Tractor Hydraulic and Transmission Fluid
Travellerｮ RENEW Tractor Fluid
no info from TS
Viscosity @ 40ｰC, cSt 59.89
Viscosity @ 100ｰC, cSt 9.32 (SUS@100=355)
Viscosity Index 136
Pour Point -39ｰC
Flash Point 224ｰC
API Gravity 30.42
Brookfield Viscosity @ -39ｰC 55,188
Mystikｮ PL AW Hydraulic Oil ISO 68
ISO Viscosity Grade: 68
Viscosity (SUS @ 100 F): 353
Flash Point: 465 Degrees F
Pour Point: -11 deg. F
Mystikｮ JT-5 Trans Hydraulic Fluid
Viscosity (SUS @ 100 F): 288
Flash Point: 457 Degrees F
Pour Point: -36 deg. F
Mystikｮ PL AW Hydraulic ISO 46
ISO Viscosity Grade: 46
Viscosity (SUS @ 100 F): 237
Flash Point: 425 Degrees F
Pour Point: -22 deg. F
Travellerｮ All Season Hydraulic Oil ISO 46
ISO Viscosity Grade: 46
Viscosity (SUS @ 100 F): 220
Flash Point: 405 deg. F
Pour Point: -26 deg. F
By JoeBuyer in forum IsekiReplies: 22Last Post: 09-25-2012, 02:59 AM
By Dave Colantuoni in forum IsekiReplies: 66Last Post: 07-31-2012, 06:04 AM
By busboy in forum Kubota Lawn & GardenReplies: 3Last Post: 07-19-2011, 04:30 PM
By honeycutt in forum Oil, Fuel & LubricantsReplies: 24Last Post: 04-25-2005, 04:05 PM
By BarryinMN in forum Oil, Fuel & LubricantsReplies: 1Last Post: 06-27-2004, 10:41 PM