Page 1 of 2 12 LastLast
Results 1 to 10 of 12
  1. #1
    New Member
    Join Date
    May 2013
    Posts
    14
    Location
    Bolton, CT
    Tractor
    Bolens H1502

    Default H1502 Wont go!

    Here goes,

    So I got this nice Bolens tractor w a Woods 48 in mower on the back. It runs great and only has 700 hrs on it. The guy i got it from said the 3 point wasn't lifing that great, so far i changed the hydro fluid twice, filter and cleaned both screens (front and back) On top of the 3 point not lifting (it goes a little bit but won't lift the mower--- (it will stay up if I get in the back of the mower and lift it) I was mowing the other night and it started acting up and whining quite a bit and now I have no reverse or drive! I barely made it back in my garage. I'm at a loss, is it the pump or something deep inside the huge drivetrain section?? Any help is much appriciated!!

  2. #2
    Platinum Member NHmitch's Avatar
    Join Date
    Mar 2012
    Posts
    924
    Location
    SW New Hampshire
    Tractor
    Bolens G154/IsekiTX1300F

    Default Re: H1502 Wont go!

    Hi,

    I wish that I could help you more, however I am not that familiar with the Hydro Tractors. If someone can help offer insight, there are quite a few parts for sale on eBay right now for your tractor: Bolens Iseki 1502H Mitsubishi 15HP Crank Gear | eBay

    The 3PH should be able to lift close to 900lbs, and the mower shouldn't be an issue. I wonder if you can test the pressure that the hydraulic pump is producing. What type of hydraulic oil are you using? Sorry I couldn't be more help with the drivetrain issue!
    Mitch

  3. #3
    New Member
    Join Date
    May 2013
    Posts
    14
    Location
    Bolton, CT
    Tractor
    Bolens H1502

    Default Re: H1502 Wont go!

    Using napa tractor oil, I didn't really think it would matter much due to the age of the tractor. Am I wrong?? Also, I added a little fluid to it, not it reads that i have way too much in there and i have drive to the wheels but the 3 point still wont lift the mower. It just seems like i'm missing something simple....

  4. #4
    Platinum Member NHmitch's Avatar
    Join Date
    Mar 2012
    Posts
    924
    Location
    SW New Hampshire
    Tractor
    Bolens G154/IsekiTX1300F

    Default Re: H1502 Wont go!

    The NAPA fluid should be fine for your tractor, but I would make sure that you don't have a leak. Make sure to check the dipstick located near your left foot. I posted a link in another thread that may help a bit:http://www.tractorforum.com/f205/bol...problem-24600/

    It may be an issue with the hydro, but I don't have a manual for your model. You can also try giving Sam a call from Sam's Bolens. He is very knowledgable about these tractors, and he can usually supply the parts that you need if you do need something. His number is at the botoom of the page:

    Sam's Bolens
    Mitch

  5. #5
    Veteran Member
    Join Date
    Apr 2000
    Posts
    1,571
    Location
    Dixon, Il

    Default Re: H1502 Wont go!

    It could be the hydro or there is a splined coupler before the hydro that goes bad.

  6. #6
    New Member
    Join Date
    May 2013
    Posts
    14
    Location
    Bolton, CT
    Tractor
    Bolens H1502

    Default Re: H1502 Wont go!

    So the tractor has been at the shop for a week now and i don't think they've even looked at it yet, the mechanic said it sounded lieks omething simple so i gave him the hydro manual and left it there. I did just see that there could be some air it the lines and maybe cracking open the hydro filter and/or some lines could potentially get it all going, any thought??

  7. #7
    Platinum Member Ilikeurtractor's Avatar
    Join Date
    May 2011
    Posts
    660
    Tractor
    Iseki TX1300F/TX1500/ TX2160F/TS2220F/ Satoh S373D

    Default Re: H1502 Wont go!

    Could be. I'm not familiar with hydros either but wouldn't think you'd need to purge the air out of any lines to make it work after the correct amount of oil is in it. If so, this should be clearly stated in the opertor's manual.
    One nice thing about being average is you're not alone.

  8. #8
    Veteran Member
    Join Date
    Apr 2000
    Posts
    1,571
    Location
    Dixon, Il

    Default Re: H1502 Wont go!

    Does the pto work?

  9. #9
    New Member
    Join Date
    May 2013
    Posts
    14
    Location
    Bolton, CT
    Tractor
    Bolens H1502

    Default Re: H1502 Wont go!

    Nothing in the manual about bleeding the lines, and the pto work fine.

  10. #10
    Veteran Member
    Join Date
    Apr 2000
    Posts
    1,571
    Location
    Dixon, Il

    Default Re: H1502 Wont go!

    If the pto works, then the problem is in the hydro. I believe the manual has test procedures for it.

Page 1 of 2 12 LastLast

Similar Threads

  1. Bolens H1502 Three Point Problem
    By dstankus in forum Iseki
    Replies: 5
    Last Post: 07-10-2013, 09:24 PM
  2. H1502 or G152 Front PTO for sale
    By amanda11270 in forum Iseki
    Replies: 3
    Last Post: 10-06-2012, 01:05 PM
  3. Bolens H1502 wont start
    By dstankus in forum Mitsubishi/Satoh
    Replies: 19
    Last Post: 09-11-2011, 08:29 PM
  4. Bolens H1502
    By msjanket in forum Iseki
    Replies: 2
    Last Post: 07-30-2011, 10:56 PM
  5. H1502 Bolens
    By msjanket in forum Iseki
    Replies: 0
    Last Post: 07-10-2011, 07:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2013 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.