JD 1050

jgbanshee · 06-28-2008, 06:24 PM

My 1050 wants to pop out of reverse unless I keep my hand on the shifter. I took the cover off and found that that reverse shift rail does not want to slide all the way into position like the other rails. The fork appears not to be bent, the detent ball bearings are new as well as the springs. Any insight?

RalphVa · 06-28-2008, 07:43 PM

On my Tacoma pickup, a little teflon bushing just below the shifter ball area broke and caused it to not stay in 5th gear. Could your 1050 have some sort of gizmo like this?

Ralph

jgbanshee · 07-04-2008, 08:14 AM

No, there is nothing like that in the 1050.

06-28-2008, 06:24 PM	#1 (permalink)
jgbanshee Silver Member Join Date: Sep 2004 Location: PA Posts: 207	JD 1050 My 1050 wants to pop out of reverse unless I keep my hand on the shifter. I took the cover off and found that that reverse shift rail does not want to slide all the way into position like the other rails. The fork appears not to be bent, the detent ball bearings are new as well as the springs. Any insight?

06-28-2008, 07:43 PM	#2 (permalink)
RalphVa Elite Member Join Date: Dec 2003 Location: Charlottesville, VA, USA Posts: 2,537	Re: JD 1050 On my Tacoma pickup, a little teflon bushing just below the shifter ball area broke and caused it to not stay in 5th gear. Could your 1050 have some sort of gizmo like this? Ralph __________________ The natural gardener God's original intent

07-04-2008, 08:14 AM	#3 (permalink)
jgbanshee Silver Member Join Date: Sep 2004 Location: PA Posts: 207	Re: JD 1050 No, there is nothing like that in the 1050.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode