Results 1 to 1 of 1
  1. #1
    New Member
    Join Date
    May 2009
    Posts
    2
    Location
    Monroe, NC

    Default JD 24T hit and miss knotters

    Hi all,
    I have a JD 24T baler. It has seen better days and has some wear and tear.

    Sometimes knot gets caught by bill hook and breaks twine (both sides). Twine is being cut by knife about 1 inch from knot.

    So far,
    New twine
    Twine pull set to manual specs
    Reduced bail weight (2 crank handles in back)
    Bill hook pressure arm set at about 12lbs (5-15lbs pull per manual) Reduced pull pressure to about 8 lbs, no effect knot still gets caught.
    Bill hook wiper seems to be in contact full length if bill hook
    Knife arm roller has no flat spots and rolls
    Shimmed knife arm up and down but still has some play left/right.

    I know from working on old cars what's in the manual may not be what the engine needs to set to for it to run right (the good old days).

    Anyone have any ideas. Please help.
    Last edited by Mini-Horseman; 06-20-2009 at 10:04 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.