JD Hay Moisture Tester question

   / JD Hay Moisture Tester question #1  

Hay Pirate

Member
Joined
Jul 20, 2007
Messages
39
Location
Orange County, NY
I have a SW16136 JD Hay Moisture tester. The wrong guys have been using it around here and ripped the wire off at the connector. All I need to do is resolder the wires onto the connector, I just need to know which wires go where.
Anyone have this model to post a pic of where the wires go? Or just tell me which number has which color. There are 4 wires, white, black, green and yellow.
Thanks.
 
   / JD Hay Moisture Tester question #3  
Not sure of the JD testers but we bought a new farmex that uses the same plugs as a 4 pin CB radio microphone and went wrong in the first week..?
 
   / JD Hay Moisture Tester question #4  
I just worked on one of these tonight, same problem.
Pin 1- Black
Pin 2 - Green
Pin 3 - White
Pin 4 - Yellow

I would add a layer of heat shrink tubing where the connector strain relief clamp tightens to minimize future slippage and pull-out. Also, apply a small amount of service removable small thread Loctite to the clamp screws.
 
 
Top