fuseboxer
Silver Member
- Joined
- May 4, 2011
- Messages
- 215
- Location
- Gaines, Michigan
- Tractor
- two john deere Sabres (2554-Scotts) and 4410 john deere ,Allis Chalmers WD , 5' Cub Cadet Zero turn
While looking for a good used 5' tiller for the 3pt on my 4410 JD I came across a man with an old snow blade that would quick attach to my 300cx loader for 400. It does not have hydro cyl but can be angled and secured with a pin. The unit was made, weldment, from a rear tractor blade years ago. Seller found a new low price blade that is a taller snow blade with a quick attach for a deere. It is set and made for a cylinder. I see three low priced older Meijer snow blades on craigslist that with some steel and welding could be quick attached to my 300cx/ 4410 Deere. Is it too heavy and too much strain for a 300cx arms? One is a few hundred more and is newer and made out of polyproplene or the newer plastic, Lexan? A lot of old truck blades are out there. What works best, cheepest, and least destructive to the 300cx? I have yet to go one winter with the use of a front bucket being used as a blade. Maybe that is all I need along with the 7' rear blade I now own.