Chris2520
Platinum Member
Finally got time to mount the new Markham tooth bar. had them make it a little narrower than normal. i wanted to weld the gusset plates to the inside. 1/4 inch plates worked perfect. I thought the 1/2 inch plates thay sent was a little over kill. i wanted a clean look on the outside of the bucket. I did not use the bolts that came with it. i used the large grade 8 bolts from the big JD tooth bar. i have not even put it in the dirt yet. and i know i am going to like it much better. i got where it just slips off with ease. i had to pry the JD bar off and beat it on with a hammer. and it weighed a ton. way over kill. this one is heavy. but not to heavy to carry around. it looks well made. The JD bar only had 6 teeth. this one has 7 teeth. thay are a plesure to work with.
I think i am going to like it. here is a few pics.....
Chris....
I think i am going to like it. here is a few pics.....
Chris....