RalphVa
Super Member
- Joined
- Dec 19, 2003
- Messages
- 7,873
- Location
- Charlottesville, VA, USA
- Tractor
- JD 2025R, previously Gravely 5650 & JD 4010 & JD 1025R
This probably applies to the 4010 and 4110.
The arms on my 3ph lift arms have 2 holes that the lift arms from the hydraulics can attach to. My came attached to the holes furthest from the tractor. The other day, I tried the putting the lift arms in the holes closer to the tractor, thinking that this would allow more lift height. Strangely enough, the lift height seemed to be a bit lower! I measured the lift heights by position on my leg down in the field. Didn't seem any different at all.
Anyone know what the story is on the 2 hole choices?
The new 2320 and/or 2520 have 2 or 3 holes in the lift arm itself. Those make a lot more sense and are certainly direct in how they work.
Ralph
The arms on my 3ph lift arms have 2 holes that the lift arms from the hydraulics can attach to. My came attached to the holes furthest from the tractor. The other day, I tried the putting the lift arms in the holes closer to the tractor, thinking that this would allow more lift height. Strangely enough, the lift height seemed to be a bit lower! I measured the lift heights by position on my leg down in the field. Didn't seem any different at all.
Anyone know what the story is on the 2 hole choices?
The new 2320 and/or 2520 have 2 or 3 holes in the lift arm itself. Those make a lot more sense and are certainly direct in how they work.
Ralph