jimjo2
Bronze Member
Does anyone else have the same problem I have with the FEL control lever being too close to my right leg when rolling the bucket back? I have been tempted to get my torch and make some re-bending to make it more comfortable.
Loader Control lever
- Thread starter jimjo2
- Start date
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,085
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
I've never noticed that on my 4300. It is positioned about as perfect as I could imagine.
What tractor model do you have?
But re-bending should work too.
What tractor model do you have?
But re-bending should work too.
AKfish
Super Member
- Joined
- Oct 1, 2004
- Messages
- 5,417
- Location
- Alaska
- Tractor
- JD 5115M; JD 110 TLB; JD 4720; Ford 9N; JD X300R
Once in awhile it was a hindrence - on my JD 970. Especially when it was colder and I had my insulated coveralls on.
Just have to be careful not to take the temper out of the control lever with too much heat..
would be more than a hindrence if the darn thing bent everytime you put some pressure on it (like going into "float" mode).
AKfish
Just have to be careful not to take the temper out of the control lever with too much heat..
would be more than a hindrence if the darn thing bent everytime you put some pressure on it (like going into "float" mode).
AKfish