Keegan4123
New member
- Joined
- Apr 22, 2018
- Messages
- 11
- Tractor
- john deer 4310
Pto switch engage with switch, light comes on but no rotation on my 2001 4310.
So I have begun my troubleshooting of my problem and I have quite a few steps left to go. During my search though I found a wire with connector that is unhooked, however I can not find where it may go. Hoping for some help.
So far trouble shooting wise:
Full flush of oil and filters
Checked wiring connections (found the one above loose wire)
Yet to do:
Volt meter on switch and selenoids, as instructed by other thread.
Check pto pressure test port not sure where this is exactly yet.
Pull back panel off and pto out and check for ported bushing alignment. Possible shift as suggested in other threads.
So I have begun my troubleshooting of my problem and I have quite a few steps left to go. During my search though I found a wire with connector that is unhooked, however I can not find where it may go. Hoping for some help.
So far trouble shooting wise:
Full flush of oil and filters
Checked wiring connections (found the one above loose wire)
Yet to do:
Volt meter on switch and selenoids, as instructed by other thread.
Check pto pressure test port not sure where this is exactly yet.
Pull back panel off and pto out and check for ported bushing alignment. Possible shift as suggested in other threads.