lildobr
New member
Hello Everyone, My 4wd quit working on me today so i came here for help. I have the light on the dash going on and off with the switch, but no engagement. I have swapped the magnetic coils around on the valve on the right side of the transmission and that only made my pto to work abnormal. I removed them and did an ohm check and they seemed the same.So next I removed the post or whatever they are called that the magnet secures to. Inside was the part with the little pin that some people said on the forum that part gets bent sometimes. It wasn't bent on either end so i put everything back together like it was. Still no luck. Can anyone else think what I should do next besides going to dealer? I don't want to do that. If I take the valve off and take it completely apart and clean and inspect it will it do any good you think? With the loader down and the front wheels off the ground they turn by hand fine with no binding. Anyone have a picture out of the service manual for the internal actuator that may of be of help. Thanks, lildobr