Results 1 to 4 of 4
  1. #1

    Default Oil seal

    i was wondering if anyone had any words of wisdom replacing the oil seal around the rear PTO on a kubota 7200. difficulty level 1 easy - 10 hardest.


  2. #2

    Default Re: Oil seal

    Did you get that seal replaced and did you learn anything that might help me in replacing the rear pto seal on my b6100? I would rate it at a 7, by the way.


  3. #3

    Default Re: Oil seal

    The shaft for my brushhawg was too long, thus when i raised it too much, it pressed the seal inward and loosened it. The rubber collar on the seal provides the pressure fit so a few hits with a rubber mallet and a 1 1/4" tube provided enough to force it in place.

    out of the package installed time: 1.5 minutes

    my rating:1


  4. #4

    Default Re: Oil seal

    I see what you mean........see my reply above!


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2013 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.