Texas Dodge
Gold Member
Can anyone tell me how to put my 3PH in float control? All I have is the position control and not the draft control too. The manual is not very self explanatory
Thanks
Thanks
So do I have float control with the rotary cutter attached?? Mine lifts when the back wheels go over uneven ground. I would like the rotary cutter to follow the contour of the land.art said:The three point hitch on most all tractors can raise up or down to the position control levers setting. So your float is there!
Continental Bronco...it's in my sig.66gladiator said:What brand of cutter?
The premium brands usually have the "float" built into the linkage of the cutter.
Texas Dodge said:So do I have float control with the rotary cutter attached?? Mine lifts when the back wheels go over uneven ground. I would like the rotary cutter to follow the contour of the land.
I think I found my answer......Double Orange said:Texas Dodge two things come to mind
1, Your top link might need to be adjusted OUT to allow it to drop?
2, there is a drop speed adjustment for your 3 p/h between your legs under your seat. Round black knob. You might have it set, to drop to slowly to compensate for the contour changes?
I have the speed adjustment set to fast. I now know that I was making the chain tight and that is why it was raising up. New to the farming thing, but I am learning.Double Orange said:Texas Dodge two things come to mind
1, Your top link might need to be adjusted OUT to allow it to drop?
2, there is a drop speed adjustment for your 3 p/h between your legs under your seat. Round black knob. You might have it set, to drop to slowly to compensate for the contour changes?