My new/old L245DT tractor did not come with an owners manual (one on order). Do I check the hydraulic fluid by just looking down the fill cap? I see no obvious dipstick or sight glass. Thanks, look forward to participating on this board
There isn't any dipstick or looking glass that I remember. If you just got it, it might not be a bad idea just to change it. Any dealer can tell you what the capacity should be. You can't tell from just looking into the filler cap because even when it is full it doesn't come up to eye level.
The L245DT has a bolt on the left side of the transmission (near your left foot while sitting on it) that is used to decide it is full. The instructions say you should fill until it comes out this hole a little bit. Just like filling a differential on a rear wheel drive car. Be careful loosening this bolt I had trouble getting mine out and ended up rounding the head so much that I had to weld a nut on it. Good luck