SailTrac
New member
- Joined
- Oct 10, 2005
- Messages
- 13
- Tractor
- BX2200
I broke a LH shear pin on the blower (my left hand), and like others I have noticed a gap on the side of the auger and the bearing flange. The only way I could find the broken pin, was to remove the 3 bolts that hold the bearing flange on the left hand side and move the bearing flange to the right. If I leave the bearing flange to the right, there is a gap between bearing flange and sidewall of the blower. Its all put back together, the gap between the bearing flange and auger is there, and if I break another pin, the auger will go left and the fun starts all over.
So one of my questions is where is mis-alignment coming from? Was the blower not set-up correctly?
Something appears to be shifted to the right (my right) Hence the gap on the left. Do I make a spacer to fill the void between the bearing flange and sidewall of the blower to avoid the 45 min shear pin replacement time? Its either a bad setup or a bad engineering.
Does any one know whom makes these for Kubota?
Love that lake effect snow.
Thank you
Mike
So one of my questions is where is mis-alignment coming from? Was the blower not set-up correctly?
Something appears to be shifted to the right (my right) Hence the gap on the left. Do I make a spacer to fill the void between the bearing flange and sidewall of the blower to avoid the 45 min shear pin replacement time? Its either a bad setup or a bad engineering.
Does any one know whom makes these for Kubota?
Love that lake effect snow.
Thank you
Mike