B7100HST tank return -- what size/type fitting

[jas67]

I'm adding remotes to my B7100HST.
There is a large bolt next to the HST filter, is that the plug for the tank return hole?

Type size/type fitting fits this, to connect a return hose?

Tanks,
Jay

 

[jas67]

I was looking through the manual. It shows the directional control valve and state the return line should hook into the case front cover, with plug removed.
Could you tell me where the case front cover is???

Is this the fill plug? I read in another thread somewhere about some fitting that goes here to connect the return line, that the plug then screws into.

Can anyone tell me where to get this fitting? Kubota part number? Is it just some normal fitting?

Thanks,
Jay

 

[jas67]

I found the answer in the following thread:
P/S B7100/7200 - Page 12 - TractorByNet.com

Elsie71 said: KubotaSam - That is just a standard 'T' pipe fitting and a short nipple. I think it is 1/2 inch, not a Kubota part.

I just checked, it is in dead 1/2 inch pipe thread.

Yahoo! Now I can complete my remotes!