Results 1 to 4 of 4
  1. #1

    Default Kubota L39 with TL1000 front hydraulic cylinders wont retract evenly and line up

    Hello<

    First Thank you in advance for responding to my post. Im trying to help my neighbor firgure out his loader problem. after using the pallet forks the now do not retract evenly the silver rods coming out of the cylinder is unequal when in the retracted position. they do not appear bent and no leaking from either end of the cylinder.

    My two questions are is there a procedure for making them even again and leveling the bucket and how do you know if the cylinder is bad and can i get it aftermarket not from kubota dealer.. any advice appreciated

  2. #2
    Veteran Member irwin's Avatar
    Join Date
    Feb 2007
    Posts
    1,279
    Location
    SE Conn
    Tractor
    2004 Kubota L35TLB, '89' Cub Cadet 1541

    Default Re: Kubota L39 with TL1000 front hydraulic cylinders wont retract evenly and line u

    Quote Originally Posted by kubotaman1938 View Post
    Hello<

    First Thank you in advance for responding to my post. Im trying to help my neighbor firgure out his loader problem. after using the pallet forks the now do not retract evenly the silver rods coming out of the cylinder is unequal when in the retracted position. they do not appear bent and no leaking from either end of the cylinder.

    My two questions are is there a procedure for making them even again and leveling the bucket and how do you know if the cylinder is bad and can i get it aftermarket not from kubota dealer.. any advice appreciated
    Does this have a SS quick attach loader bucket? If it does than the SSQA is twisted.

    The loader arm cylinders are held in alignment by the bucket... or the SSQA.
    Remove the bucket on a pin on style and the cylinders can easily be uneven.
    .....Tim

  3. #3
    Veteran Member
    Join Date
    Jun 2003
    Posts
    1,649
    Location
    Northern, New York
    Tractor
    Kubota L3830 03: RTV 900

    Default Re: Kubota L39 with TL1000 front hydraulic cylinders wont retract evenly and line u

    kubota must be having a problem with those QA, that part that is on the tractor. I bent mine on my M-5040. My neighbor has an L-3240 and he bent his. The tube that holds the two plates together seems to be to light of a material. I replaced mine with a piece of solid stress proof round bar.
    M-5040 w/cab, 05 RTV 900, Where the maple sap flows

  4. #4
    Silver Member
    Join Date
    Sep 2010
    Posts
    153
    Location
    Mississippi
    Tractor
    Kubota M9540 HD 4x4

    Default Re: Kubota L39 with TL1000 front hydraulic cylinders wont retract evenly and line u

    I just bought a used M9540. I did notice the tube that holds the two plates together is bent, but didn't think anything of it. When I disconnected from the bucket and tried to hook up to my forks is when I noticed that the ssqa is a little out of line and makes things difficult. I thought about cutting this tube a few inches from each side (away from the bent area) and weld some pipe to the inside. 2" OD pipe is a little too small, does any one know the correct size? Any other suggestions?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.