fisherridge
Member
I have a non-Kabota TLB with a Kubota D1105 3 cylinder diesel engine.
I am having oil pressure switch wiring problems. The instrumentation is idiot lights.
The oil pressure switch has three terminals.
The wire from one terminal goes to the idiot light.
One terminal has no wires attached.
One termminal connector has three wires.
One wire comes from the temperature sender, one wire goes to a bell housing bolt near the fuel shut off solenoid.
The third wire is my problem.
It runs to the dashboard area, but I don't know if it is for power, ground or what.
Any help will be greatly appreciated.
I am having oil pressure switch wiring problems. The instrumentation is idiot lights.
The oil pressure switch has three terminals.
The wire from one terminal goes to the idiot light.
One terminal has no wires attached.
One termminal connector has three wires.
One wire comes from the temperature sender, one wire goes to a bell housing bolt near the fuel shut off solenoid.
The third wire is my problem.
It runs to the dashboard area, but I don't know if it is for power, ground or what.
Any help will be greatly appreciated.
Last edited: