Newbie - Introduction

[Popster]

Greetings,

I was referred to this site from the fine folk on Yesterday's Tractors 8N board.

I just bought a L2850 and am eagerly looking forward to learning from this site. I am located in Southern Maryland.

 

[repete]

Welcome! A L2550DT owner here. Tell us about your machine and implements you may have.

 

[TripleR]

Oh and don't forget the pictures.:thumbsup:

 

[RadarTech]

Oh and don't forget the pictures.:thumbsup:

absolutely!!

Pictures are the life blood for those of us that are stuck inside!!!!

Please post em!
J

 

[PHILIP8N]

Welcome, I used to spend allot of time at ytmag, good group. I still have my 8N, but my L3940 does most the work now. Philip.

 

[TripleR]

Welcome, I used to spend allot of time at ytmag, good group. I still have my 8N, but my L3940 does most the work now. Philip.

Very nice looking 8N:thumbsup:

 

[Baby Grand]

Welcome aboard! You came to the right place.
-Jim

 

[AceDeuce]

That's a neat-looking attachment on your 8N. Never seen one like it before. What do you use it for?

 

[johnrex62]

Looks like a portable saw mill, don't it Ace?

I like your light setup on the L3940, but where is the top of your ROPS? Shhhh! Don't show this pic to the safety police. heh heh

 

[Verticaltrx]

That's a neat-looking attachment on your 8N. Never seen one like it before. What do you use it for?

That would be a cord wood saw. Before the invent of chain saws you used a saw like that to cut small logs into firewood length pieces.