I looked high and low for a spanning wrench to adjust my Left Arm Leveling Assembly, instead of using the hole at the end of my adjustable wrench. I was tired of the wrench slippting off the end of the metal rod and busting my knuckles from time to time. Sometimes, pain is a great prompter of thinking, so I built one out of a piece of 3/8 re-bar.
It works quite well, and can be reversed for raising or lowering my blade in the dead of winter, expecially when I adjust the angle of the blade to avoid tearing up my gravel driveway.
Attached are a couple photos if you are interested.
It works quite well, and can be reversed for raising or lowering my blade in the dead of winter, expecially when I adjust the angle of the blade to avoid tearing up my gravel driveway.
Attached are a couple photos if you are interested.