Delphicoder
Silver Member
Hi All.
I hope this is not a dumb question, but probably is
So I was removing stumps today and getting the hang of the BH65. Something felt odd and I was not really sure why. At first I thought it was just me, since I was used to my previous tractor BX25. Seemed jerky under some circumstances,
So I started to pay attention a little more. To my surprise, I found that if my left hand pulls back, and then while doing that my right hand pushes left, the left hand movement gets cancelled until I go back to neutral on the right hand. All other combinations seem to work just fine.
I looked in the BH65 manual, and I did not see anything that stated you could not raise the boom and curl the bucket at the same time. I do have my three point hitch lever locked on the down position like the manual states, if that has anything to do with it.
Anyone else ever came across something like I described?
Thanks in advance as always.
I hope this is not a dumb question, but probably is
So I was removing stumps today and getting the hang of the BH65. Something felt odd and I was not really sure why. At first I thought it was just me, since I was used to my previous tractor BX25. Seemed jerky under some circumstances,
So I started to pay attention a little more. To my surprise, I found that if my left hand pulls back, and then while doing that my right hand pushes left, the left hand movement gets cancelled until I go back to neutral on the right hand. All other combinations seem to work just fine.
I looked in the BH65 manual, and I did not see anything that stated you could not raise the boom and curl the bucket at the same time. I do have my three point hitch lever locked on the down position like the manual states, if that has anything to do with it.
Anyone else ever came across something like I described?
Thanks in advance as always.