Anonymous Poster
New member
- Joined
- Sep 27, 2005
- Messages
- 0
I pulled the moror out of my early 80's B 7100 this morning after getting a severe oil leak yesterday morning shortly after start-up and found that a little plug blew out of the timing cover on the bottom of the cover in an oil passage. Just as a precaution, I also pulled the flywheel off and found that the rear main seal blew out of the back of the block also... Anyone had this problem before and what did you do about the plug in the timing cover if so? The rear main is no problem and I will check and clean the oil pressure relief before reassembling but the plug in the cover looks like it may be a problem cause I don't believe it was every supposed to come out even if you wanted it to... Any ideas anyone... Suggestions?... Thanks in advance... Visa...