lgoldy46
New member
L35 Steering lever pin. Shop manual said remove retainer and lift out pin.
Pin will not budge. With the axil in place only part of the bottem end of the pin is exposed,
with a drift pin I could hit upward (didn't move). I welded a half in. metal bar on top of the pin so I could pry up under the bar
[no luck]. The bar I welded on exstends 2 INs. wider then the pin, so I tried beating on the end of the bar to turn the pin to
brake it loose [bent the bar].
If axle was removed, can the pin be drove down or is there a sholder on pin to stop it from falling out of the bottom.
Any idea of what to try next? :confused2:
Thank you
Larry Goldsberry [Lgoldy46@aol.com]
Pin will not budge. With the axil in place only part of the bottem end of the pin is exposed,
with a drift pin I could hit upward (didn't move). I welded a half in. metal bar on top of the pin so I could pry up under the bar
[no luck]. The bar I welded on exstends 2 INs. wider then the pin, so I tried beating on the end of the bar to turn the pin to
brake it loose [bent the bar].
If axle was removed, can the pin be drove down or is there a sholder on pin to stop it from falling out of the bottom.
Any idea of what to try next? :confused2:
Thank you
Larry Goldsberry [Lgoldy46@aol.com]