jeep07
New member
- Joined
- May 3, 2011
- Messages
- 18
- Location
- Kingsport, TN
- Tractor
- Husqavarna CZ1740, Case 1825 Skid and Kubota B2920 TLB
2+ Years ago I picked up a toothbar at an auction for $100. It was made for a 60"+ wide bucket. I decided to make it fit the Kubota.
First step was cutting it down and then develop a method to attach it.
Marking It
Cutting with Portaband
Then I needed to develop a way to secure the bar to the bucket. Some 4" plate I had laying around so I figured contour to the bucket and then use some binders on the back side to cinch the bar down. (Binders aren't installed yet, had to stop for the night).
4" Plate before and after.
Bending it in my Swag/HF brake.
Welded up.
Test fit. Comes on and off easy.
Strap contoured to bucket.
Backside where I will attach a binder to strap and then weld an attachment point on the bucket.
About 2 hours of work start to finish including setup/cleanup. I'm looking forward to digging some holes this spring.
I'll update this as I add the binders this week.
First step was cutting it down and then develop a method to attach it.
Marking It
Cutting with Portaband
Then I needed to develop a way to secure the bar to the bucket. Some 4" plate I had laying around so I figured contour to the bucket and then use some binders on the back side to cinch the bar down. (Binders aren't installed yet, had to stop for the night).
4" Plate before and after.
Bending it in my Swag/HF brake.
Welded up.
Test fit. Comes on and off easy.
Strap contoured to bucket.
Backside where I will attach a binder to strap and then weld an attachment point on the bucket.
About 2 hours of work start to finish including setup/cleanup. I'm looking forward to digging some holes this spring.
I'll update this as I add the binders this week.