rbarker
Veteran Member
Made it through the whole blizzard of 2013 with no problems but today on light clean up I picked up a stick and sheared the fan pin. I'm new to this blower but was smart enough to buy a dozen spare pins at the suggestion of the salesman and the good folks here on TBN. Unfortunately the bolt sheared off clean on both sides and I have no clue how to find the proper alignment in order to drive out the old bolt. I poked around in there with an awl while turning the fan and thought I might have found it but if it is then its not going to come out easily.
Any tips on how to accomplish this without deconstructing the blower and using all those words my Momma told me not to say?
Sent from my iPad using TractorByNet
Any tips on how to accomplish this without deconstructing the blower and using all those words my Momma told me not to say?
Sent from my iPad using TractorByNet