Bx2660 woods rcc42

[Maestro71]

Will my bx2660 work we'll with a woods rcc42" rotary cutter? Thanks all.

 

[Maestro71]

Will my bx2660 work we'll with a woods rcc42" rotary cutter? Thanks all.

I also wanted to know how to tell the difference between a driveshaft with a slip clutch or shear pin. Thanks.

 

[unbidden]

I run a 48" brush cutter on my BX2660 with no problem.

PTO Slip Clutch, 1-3/8 in. 6 in. Spline Shaft - Tractor Supply Online Store

PTO Slip Clutch, 1-3/8 in. Smooth Shaft - Tractor Supply Online Store

 

[Maestro71]

I really appreciate it. can you tell from the pic if it has a slip clutch.

 

[TripleR]

I run a Land Pride 48" rotary cutter with my BX2660. You should be able to download an manual on your cutter from Woods to see the slip clutch and how to maintain it.

If not, you can download one from Land Pride and you will see pictures and descriptions for the slip clutch; we have LP and Woods.

 

[Maestro71]

Thanks I didn't get it yet I'm goaing to see it tomorrow I was wondering if it is possible to tell from the pic if it has a slip clutch

 

[TripleR]

It is hard to tell from that angle at least for me, here is a picture of mine with a slip clutch, maybe it will help.

 

[Maestro71]

Thank you that helps a lot ill check it out.

 

[radioman]

yup hard to tell from pic -- you gotta look under the pto collar on cutter. and it should work. 42 is well under 48" limit of the BX.

 

[Maestro71]

My manual says not to go over 42" but if I could find a deal on a 48 I'd jump on it. The little ones are few and far between in my area. Northeast Ohio if anybody has one. Thanks for the input.