Kickstand
New member
I recently bought a 1997 L35 with 1270 hours. The front axle lube is low. Reading the manual, it says you can use either Kubota SUDT, UDT, or 80-90 weight gear lube. I don't know what's in it now. I'm surprised that fluids of such different viscosity are both ok. I'm leaning towards using the 80-90 weight gear lube because I see some evidence of leaking where the axle turns down toward the wheel on both sides and I figure the heavier grease will be less likely to leak. Which should I use? Should I worry about a little leakage?
Any thoughts on this subject would be greatly appreciated.
Joe
Any thoughts on this subject would be greatly appreciated.
Joe