JimC
Silver Member
Here is what I rigged to add transmission fluid to a BX 2200,
I used a 1 1/2 " electrical elbow (I had it on hand)
I used a heat gun to insert a 1" coupler into the elbow
(if you use a 1" elbow forget about the heat gun and the coupler)
a piece of 1" pvc pipe, and a 1" threaded adapter
DO NOT USE GLUE.
screw the adapter into the filler hole on the BX 2200
assemble the pvc pipe, insert a large funnel into the elbow.
Add the UDT fluid. Much better than a flexable hose.
See photo.
jimc
I used a 1 1/2 " electrical elbow (I had it on hand)
I used a heat gun to insert a 1" coupler into the elbow
(if you use a 1" elbow forget about the heat gun and the coupler)
a piece of 1" pvc pipe, and a 1" threaded adapter
DO NOT USE GLUE.
screw the adapter into the filler hole on the BX 2200
assemble the pvc pipe, insert a large funnel into the elbow.
Add the UDT fluid. Much better than a flexable hose.
See photo.
jimc