MODiesel
Silver Member
OK. So, I've got this great new orange-colored tractor, and I've had to trailer it between two of our properties a few times. However, I've been stumped as to figuring out good chain down points.
What I've been doing, so far, is to run a chain through the round cross support in the LA853 loader, and another around the lower 3-point arms at the rear. The problem, though, is that the chain is marring the edges of the loader, and I'm not even sure where I could tie down on the front if I don't have the loader attached.
What have you guys figured out? On my TC40D, NH at least gave you one loop on the underside of the chassis towards the middle of the tractor. However, on the L5030, the bottom is much cleaner, and even the front of the frame is occupied with the brush guard. So, I'm looking for suggestions from those of you who have already dealt with this one! /forums/images/graemlins/smile.gif
Regards,
Jay
What I've been doing, so far, is to run a chain through the round cross support in the LA853 loader, and another around the lower 3-point arms at the rear. The problem, though, is that the chain is marring the edges of the loader, and I'm not even sure where I could tie down on the front if I don't have the loader attached.
What have you guys figured out? On my TC40D, NH at least gave you one loop on the underside of the chassis towards the middle of the tractor. However, on the L5030, the bottom is much cleaner, and even the front of the frame is occupied with the brush guard. So, I'm looking for suggestions from those of you who have already dealt with this one! /forums/images/graemlins/smile.gif
Regards,
Jay