lost power to my dash gauges

[dirtdabbler]

Originally Posted by MississippiMan

dash went dead on my 5525. the fuses are good, at least the ones i know about which are below and to the left of the steering wheel. last time i used it everything was fine, today, no dash gauges.

anyone have a clue where i should start looking to resolve this.?

I have a brand new 4110 and this same thing is happening to me... Started about three weeks after purchased.. I called the place I bought it and they didn't know.... They told me to check the ground and see... I haven't done it yet... At times it works and other times it doesn't... With mine it is mostly the fuel Gauge that doesn't work.. and occasionally the temp gauge follows suit... It sounds like a faulty curuit board or a ground..

[MississippiMan]

just to update this thread.

today me gauges just came on by themselves. that makes me think it is a ground for sure.

with other things i have going i just haven't had the time to check it out yet.

[LAWALLSTRACTOR]

Check the plugs on the back of the dash panel.

[MississippiMan]

correction, i said ground and what i meant to say was an electrical connection.

[ribchord]

Originally Posted by MississippiMan

all of the dial gauges are not working. turn signals, headlights, horn etc all work. tractor runs fine. i am 40 miles from a dealer and i don't have a trailer anyway. hoping i could fix it myself.

if your tach is also not working then your altenator is broke

[dirtdabbler]

Just an update.. My dealer called Mahindra and they sent an entire new Panel module to replace my other one... Basically four screws and some plug-ins to unplug... They Exchanged the whole assembly...