Anyone have any bright ideas about where to mount a tool box on one of these? It seems as if every good space is taken. I have the backhoe so can't go behind seat.
If u design it with same concept as the weights people put in that location, on all sorts of tractors, it maybe just as easy to put on or take off as the weights.
I built a tool box this morning. It's made from 1/8" plate and measures 8" high by 8" deep and 22" wide. I plan on adding LED marker lights to the sides for winter plowing.
I think you did a great job! That's where I was thinking, except I was picturing trying to incorporate it into the brush guard. What made you decide to remove the brush guard?
I plan on building a new bush guard to bolt on between the tool box and frame. It needs to be built so that the lid will open fully yet still protect the front.
I built a tool box this morning. It's made from 1/8" plate and measures 8" high by 8" deep and 22" wide. I plan on adding LED marker lights to the sides for winter plowing.
Spent the day digging out a bank for a garage. The tool box hit the bank a few times when I was back dragging the hill to smooth it off. No damage other than a bit of dirt on the box.