|
|
|
|
|
|||||||||||||||
|
|
|||||||||||||||
|
|
#1 (permalink) |
|
Bronze Member
Join Date: Dec 2005
Location: Conroe TX
Posts: 53
|
i was looking to see how hard it was to hook up a trailer light connection
"4-way" on my tractor, i noticed under the seat that there is a green plug, is there a adapter that the dealer sells for this hook up, mybe some one has done this before??? thanks for any reply's.
__________________
5500 4WD 22' Goose Neck trailer Mohawk 7' cutter ARMSTRONG 6' BB Bail spear 9" & 12" Augger 6' Angle tilt grader blade J.D. Zero Turn-465 62" Deck New 07 Dodge 1-ton dually, 6.7L, |
|
|
|
|
|
#2 (permalink) |
|
Silver Member
Join Date: Feb 2006
Location: Missouri
Posts: 206
|
I have a 6000 2WD so I am not certain that the wiring harness is the same as on the 4WD. However, on my tractor the unused "under seat" connector is 3 wires; ground, always hot, and hot when start/run switch is on. None of the three are connected to any of the lighting circuits. I wanted to use this to power a solenoid valve to switch chemical on/off for my sprayer. Dealer couldn't identify a part number for an opposite gender connector with pigtails. After enquiry here, MUSA said they would consult tech support. Received no further info. I just bought a couple of tap connectors and a cheap 2 wire male/female connector set and did my own thing.
|
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|
|
||||||||||||||||||||||
| About TractorByNet.com | Terms of Service | Advertise | © 2008 TractorByNet.com |