MrFar
New member
Just bought the tractor and when I went to use the loader I found that it won't lift more than about 100 lbs of material and is very slow to lift even when empty. On down pressure it will lift the wheels but when I release the lever the front drops back to he ground. The loader will hold up in place but gradually will fall back down several inches over a few(10) mins. It held in place over night falling only slightly when off. Fluid looks clean on the stick and I added more(TDH) to bring it back up to full from the low line. All the side controls seem to operate correctly and the 3 point raises and lowers smoothly with no load so far though. I have searched and read quite a few posts and sounds like the filter should be checked and cleaned. Also there is mention of a pressure release valve, but I haven't found out exactly where that is. The Pto is the 3 position one. Suggestions on where to begin would be greatly appreciated as I am new to this.
Thanks
Mark in Canada eh.
Thanks
Mark in Canada eh.