Results 1 to 1 of 1
  1. #1
    New Member
    Join Date
    Jul 2012
    Posts
    8
    Location
    anna, il
    Tractor
    MF

    Default Massey 135 governor on 70 Perkins gas

    Need help with governor adjustment

    Hi to all on the forum

    I enjoy the forum and have learned lots here.

    I just purchased a 1970, 135 with 1,000 hours on a Perkins 3 cylinder gas. It has been well maintained, always garaged, and starts and runs great. It does leak oil from the flywheel housing weep hole, so I assume the rear main seal is bad. The leak is small and should not affect the clutch. Is there any problem with leaving the old seal in and just adding oil as needed?

    So far I have only used it to power a 4ft bush hog, which is small for the 135. The RPM seems to be low at top end (full throttle). It runs smoothly, with no smoke, and has good power. Top RPM is around 1,500 with a load or with no load. I've read that the top RPM should be more like 2,200 RPM.

    Does the governor have an adjustment device? Power is good and the governor maintains good RPM under load but it seems the RPM should be higher. The carburator, distributor, timing, etc seems to be correct and it runs smoothly at all RPM.

    Thanks for any help. I do not have a service manual.
    Last edited by beesink; 09-10-2012 at 09:31 PM.

Similar Threads

  1. Massey Ferguson 135 Perkins Gas
    By fishingbucks in forum Massey Ferguson Classic/Vintage
    Replies: 4
    Last Post: 05-03-2010, 06:01 PM
  2. 135 Perkins Gas
    By Texas Blues in forum Massey Ferguson Classic/Vintage
    Replies: 0
    Last Post: 10-02-2009, 11:41 PM
  3. Massey 135 Carburetor For Perkins
    By Texas Blues in forum Massey Ferguson Classic/Vintage
    Replies: 1
    Last Post: 08-06-2009, 10:00 AM
  4. Massey 135 governor
    By Texas Blues in forum Massey Ferguson Classic/Vintage
    Replies: 6
    Last Post: 06-12-2009, 11:46 AM
  5. New guy with MF 135 w/Perkins gas engine
    By krue in forum General Vintage Tractors
    Replies: 16
    Last Post: 09-16-2006, 11:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
© 2014 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.