Hi, I need to drop the oil pan on my Z134 engine, and since bolts and nuts are everywhere and running in all directions, is there anything more to doing this that just taking all the fasteners out and removing it? I would hate for the tractor to break in half
I just brought this home and it runs perfect, the plugs look good, no problems-except low low oil pressure. I though the first gauge did not even work, replaced it and new one moves a bit, and increasing the revs barely moves it at all, almost gets out of red part of gauge but does not. No knocks or strange noises so far.
After research, I hope to find the relief valve spring is stuck or some issue like that.
Another question is that NAPA sold me a oil filter that barely fit, and I am not sure the spring is pushing the filter against the bock, dont know if washer is there at all-does the filter install have any potential affect on oil pressure? I will get that corrected soon as well.
Thanks in advance..
I just brought this home and it runs perfect, the plugs look good, no problems-except low low oil pressure. I though the first gauge did not even work, replaced it and new one moves a bit, and increasing the revs barely moves it at all, almost gets out of red part of gauge but does not. No knocks or strange noises so far.
After research, I hope to find the relief valve spring is stuck or some issue like that.
Another question is that NAPA sold me a oil filter that barely fit, and I am not sure the spring is pushing the filter against the bock, dont know if washer is there at all-does the filter install have any potential affect on oil pressure? I will get that corrected soon as well.
Thanks in advance..