Results 1 to 3 of 3
-
07-11-2010, 12:32 PM #1New Member
- Join Date
- Jul 2010
- Posts
- 1
- Tractor
- MF 135
MF 135 zenith carb problems
tractor runs only with choke pulled all the way out, pretty rough but I can do most jobs with it that way, cuts out then comes back. Fuel filter is clean and ran some spray in carb cleaner. Reluctant to start messing with adjustment knobs. Also on this carb there is a wire that is connected to main adjustment. I was thinking of running some gas additive carb cleaner next. If no fix then a rebuild kit for carb .I have had this tractor since 96 and has been tuned 3 months ago . any quick fixes?
-
07-11-2010, 01:12 PM #2Platinum Member
- Join Date
- Jun 2010
- Posts
- 851
- Location
- Annapolis Valley, Nova Scotia
- Tractor
- MF 135 Z134 Continental
Re: MF 135 zenith carb problems
Did you do the tune-up yourself or have it done? I had a similar problem once and it was a linkage problem, check to make sure all the rods / spring etc are free from obstuction and operating properly.
-
04-22-2012, 01:14 AM #3New Member
- Join Date
- Apr 2012
- Posts
- 1
- Location
- spring city,tn
- Tractor
- massey ferguson 135
Re: MF 135 zenith carb problems
I have the same promblem rebuilt carb,new fuel filter, sediment bowl clear,tank clean , new plugs,wires,coil, points distr. cap and button. runs sometimes fine then want run without choke pulled and thats at idle what would i do? I have the zenith none adjustable carb and no wires or fuel shutoff on carb.
Similar Threads
-
MF 135 remote install(tisco) problems
By Dirtleg in forum Massey Ferguson Classic/VintageReplies: 11Last Post: 06-22-2010, 09:18 PM -
MF 135 PTO seal
By Rick Koudys in forum Massey Ferguson Classic/VintageReplies: 5Last Post: 12-30-2009, 08:13 AM -
MF 135 Wiring help needed
By madmrallysport in forum Massey Ferguson Classic/VintageReplies: 5Last Post: 05-03-2009, 12:23 PM -
Used MF 135
By Grapeman in forum Massey Ferguson Classic/VintageReplies: 5Last Post: 04-16-2008, 12:37 PM -
1020 carb problems, still
By heehaw in forum John Deere Owning/OperatingReplies: 4Last Post: 01-04-2002, 08:55 AM


Reply With Quote
