Results 1 to 1 of 1
03-11-2010, 09:00 AM #1
- Join Date
- Nov 2006
- Washington, Pa.
- McCormick CT36HST w/FEL, Kubota G2160
Checking hydro fluid level on a CT36HST
In my opinion, the manual that comes with the tractors could be written a little better. I like the tractor though !!!
I believe that the check point for the hydro fluid, for the whole system, is on the rear axle housing in the lower right side ? ( If you are standing behind looking forward ) Can someone verify that this is correct ?
I've been looking at the engine oil and hydro fluid and they have remained at the same levels.
I plan on doing the 50 hr service myself and it looks to be muh easier without the FEL attached.McCormick CT36HST w/FEL,
FEL Stump Bucket,
6 ft BB, hyd top link,
Wallenstein GX720 BH,
Land Pride PR2572 Powered Rake,
15 KW PTO Generator,
Pat's Easy Change,
Ground Works Debris Rake 2.
Kubota G2160 w/60 inch deck.
Oil & Fuel Hydro fluid mixing with engine oil.By Grubs in forum Kubota Owning/OperatingReplies: 5Last Post: 03-15-2010, 09:12 PM
By JSUnlimited in forum New Holland Owning/OperatingReplies: 20Last Post: 10-07-2009, 11:11 PM
By Dr. Bob in forum Kubota Owning/OperatingReplies: 6Last Post: 07-11-2009, 11:03 AM
By randy Wright in forum Kubota Owning/OperatingReplies: 12Last Post: 12-22-2007, 03:22 AM
By Clymer in forum Kubota Owning/OperatingReplies: 5Last Post: 09-25-2006, 09:39 PM