Has anyone here used any of these type machines? I have a lot of 3" and smaller pipe along with t-post to drive in the ground and prefer not to use a auger or drive by hand. I have been looking at these post drivers and so far I haven't seen any negative comments, but not sure if I am seeing...
Do you climb in the truck bed every time and connect/disconnect the latch or hook-up chains?
I've always had a standard tongue pull or RV style 5th wheel, now I have a horse trailer that will primarily be used by my wife. I don't see anyway of hooking it up or disconnecting it without climbing...
Has anyone heard of these before?
I bought a used trailer and it has 4 brand new Gold Crown GC908 Trailer Tires on it, load range E (2830lbs Single load at 80psi).
I tried to research on internet, but couldn't find much about them.
I built a firewood rack out of tubing using a bandsaw to make saddle cuts. I think the same thing could be accomplished with a cutoff saw.
This is a video that basically shows how to do it.
How to make a Saddle Cut with a bandsaw - Instructable - YouTube
I have some metal lines for power steering on an old tractor that were bent and now leaking. What is the best way to repair this without replacing the whole metal line?
Just bought a used 2013 L4600 tractor with 32 hours on it. Feel like I should change the oil, but didn't want to drain out any "special" break in oil that may be in there. Am I thinking to much into it or should I just change the oil?
While using a Bush Hog 3210 the drive-shaft came apart. This coupling or "central body" appears to be completely destroyed. Can these be rebuilt?
Thanks