Recent content by abwehrly42

Thank you gentlemen. I have a gauge and guage port on the way so I can adjust this relief valve properly.

My understanding is that my hydraulic pump produces 2200psi (YM1500 Hydraulic pump capacity - Yanmar Tractor Support Message Board), in which case I would want the loader to receive full pump pressure. Or have I misunderstood and the pump is limited to 2200psi by the relief valve?

Thank you oldnslo. This circuit continues to the 3 point. Since there is another relief valve in the system can I disable this one? Add enough shims so it would never open.

This loader valve was originally on a Steiner LD300 attachment. Where would I find the adjustment for the relief pressure? I don't want to start pulling caps and having springs and spools popping out.

I recently built a frame to adapt a loader to my YM1500. It attaches to the front bumper, the frame in front of the bellhousing, four tapped holes in the cast transmission housing, and four holes at the bottom of the rear axle. If I wanted to upgrade to a larger Yanmar are there any that would...

M6 x 0.75mm https://www.mcmaster.com/catalog/129/2518/1105K16

Thanks for the information!

Yes, with all the pertinent information to the question I am posing.

Are these components sourced off a larger tractor? Since this axle is no longer available from Hoye I would like to build my own. Any suggestions for strong spindles to start with?