Recent content by appleo

Lol. try this again. While using the backhoe, the stabilizer arms lose some pressure and the backhoe chassis sags downward toward the earth. I must tap the both stabilizer levers to activate the stabilizers in order to bring the backhoe up again to commence digging properly

Have this backhoe on my ck30 with 350 hours on the tractor bought used clean Both stabilizer arms on the backhoe seem to lose some pressure and the backhoe frame sags downward. i’m always tapping the stabilizer controls to keep/ pump the pressure up is there a single valve or obvious cause...

looks like my old ford 8n red rear fender toolbox

built one this week with scrap lumber and harbor dollys

I bought the factoiry bumper grille for my CK30 Not much help when brushhogging Wanted a metal mesh Easiest solution was to buy one of those 500 lbs. Capacity 48 in. Hitch Cargo Carrier Made by Highland Come in two pieces You only need one half Bolt it onto your Kiotii bumper...

Hello....I currently have a KB2465 Backhoe mounted on a Kioti CK30 gear, purchased second hand with 250 hours. Backhoe has seen little use. Prior owner used FEL mostly Backhoe seems to work strong with the nuisance the hydraulic stabilizer arms appear to sag while operating the boom ...

is there a valve or switch to shut off flow to the rear backhoe>? 2008 CK30

Looking to buy new set of ag rims need to know bolt pattern ck30 2008 275 hours also any aftermarket rim suppliers?