Recent content by Bob Warner

The factory wiring harness is fried. I want to make a new wiring harness from scratch and have a schematic. However I have never made a wiring harness before and would like suggestions. I can get the correct wire sizes and colors, ends and all parts I need but my major issue is really routing...

Hello all, I have a Ford (MF) 2610. It sat for 5 years before I got it. I changed fluids and filters and if fired up and ran great. Been using it about a month and drive it almost every day. Today I had it running and it started to cycle like a stuck float on a lawn mower. It did that for...

I just got a Ford 2610 tractor with a 2400QTfront end loader. I want to make a quick change adapter for it but want to be sure I do not cut myself off of other premade attachments in the process. My fabrication skills are good and I can make about anything I want. In this case I want to remove...

Hello all, I recently got myself an IH 404. I am changing all the fluids but am confused about one thing. The hydraulic/trans fluid change out. I know where to drain it, I know where to add it but I do not know where the hole is that tells me it is full. The books says to remove a plug and...

Hello all, I was referred to this forum by wroughtn_harv, so don't hold it against me. Harv and I are friends and live close together. Anyway, I just became the owner of a 1962 International Harvester 404 tractor. Unfortunately it belonged to my boss before me and he "worked" on it before I...