Recent content by boner58

I am wondering if there is a "bracket" or box or something I can add to to my tractor/loader so when I take off my loader I will have an easy place to disconnect all the hoses. I see these on all the new tractors just curious if there is something aftermarket or anyone has an idea to build one

Thinking of making a barb wire unrolled for a 3 point hitch. Any one have any ideas? Pictures? Was thinking of taking some heavy square pipe and put 4 discs with 4 upright solid round stock.

Thinking of making a barb wire unrolled for a 3 point hitch. Any one have any ideas? Pictures? Was thinking of taking some heavy square pipe and put 4 discs with 4 upright solid round stock.

I know there has been countless threads on this both about buying and building, so I am going 1 more thread to the list. I have a 4020 JD with a 7 foot bucket and I keep breaking it trying to dig, so I am the point where I believe a tooth bar would help me out. Looking for one the is 83 3/4...

I know this is not high quality saw, but it only has 4 hours on it and it was given to me. After I replaced the fuel lines and cleaned the carb, I put it together and it starts on the first or second pull but will only run until it gets hot, then quits. After it cools down it will do the same...

So I have been wondering if anyone has taken 2 5 foot brush hogs to make a 10 foot brush hog? I know anything can be done but should it? what would be involved? a good used 10 foot goes for about 4000 while used 5 foots go for about 500 Just thinking about it I would have to be able to turn the...

So I have a 30 x40 pole barn with a cement floor, and that shed it just way to handy not to have it. But it has 1 minor flaw, when it rains out side it rains inside so far i have counted 15 different leaks. some would be from nails, some would be from the fiberglass panles that let in light...

I am about to set out and build a pipe and cable fence around my house, in order to keep my bison inside or the rest of the world outside depend on which side of the fence you are on. but I am wanting to build 3 16 ft and 2 5ft gates out of 1.5 3/16 wall square tubing and would appreciate any...