Recent content by BXMMCC

Whenever I get a new attachment, I buy a dolly for it if applicable. I usually get the inexpensive model at Tractor Supply Company. So what? Check the nuts holding the castors - after a year or two, ALL the nuts were loose and a few were missing. (And I did check them before putting them into...

Using the rake the other day, just happened to hear a metallic clink when lifting the 3pth. Found the right upper lift arm's hairpin clip on the ground. What happened - the lift arm pin evidently rotated into a position that had the clip inverted and at such an angle that the straight end of the...

can\'t get to tbn For the past three days, I haven't been able to get to TBN by using the url that I have used for a year or more - http//www.tractorbynet.com. Today, same thing - symptom is that it connects to the home page - the IE banner shows Trctorbynet.com|John Deere,Kubota, etc., but the...

The well water never smelled really bad before this spring. I would say it smells like sulphur. Could it be because of all the rain? The well is about 160 ft. deep.

I'm gonna put a strip of horse mat on my rear blade. How far should it stick out beyond the normal cutting edge?

On my BX2200, I just noticed that the steering cylinder (I guess that's what it's called) on the left side where it connects to the ball joint assembly, the cylinder has about an eigth of an inch of unfinished material before it enters what looks like a big, oddshaped nut. On the right side...