Recent content by CECILSSTEEL

Getting ready to put a 5 ft Covington Rotary Cutter back in service. This cutter was orginally used with Ford 600. PTO shaft is all steel and both end yokes are 6 spline 1-3/8 dia with center holes, one end directly to the overrunning PTO clutch on the Ford and the other end directly to spline...

Any suggestions on replacing a single stage clutch on a Ford 600 inaddition to the instructions listed in the Ford shop manual. Will start to split the tractor in half this week. Thanks, Cecil

Pictures attached, results from restoring Ford 640. Enjoyed this project. Thanks for the information from the forum.

Recently came into possession of my uncles 640 Ford that he purchased new back in the late 50s. Appearance wise the tractor has weathered and a complete paint makeover is in order. I plan to repaint to the original color scheme and would like to use a durable corrosion resistant weatherable...

What is the best cultivation tool that can be mounted on a Ford two row cultivator frame for controlling nutsedge near or in the row. Planting peas, beans, and corn in sandy soil. Currently using sweeps to cultivate between the rows but need to get closer to the row.

I recenty restored an old 4 blade disc tiller. Before and after pictures are attached. This implement dates back to the 1950's. I planted a cover crop of oats for my garden plot in the fall. I plan to lime and turn the oats under with the disc tiller in late December' then followup breaking...

I need to replace the discs on a 1950's Krause disc tiller (single axle 4 disc plow). The disc tiller requires 26 in disc with a 4.5 inch concavity which is higher than the 3.5 inch standard concavity used on harrow discs of this diameter. Who would be able to supply this type replacement...