Tab Content
  • clemsonfor's Avatar
    Yesterday, 09:45 PM
    With all that wrong unless you get a deal on a parts tractor I think you now have a parts tractor?
    22 replies | 1195 view(s)
  • clemsonfor's Avatar
    11-14-2017, 07:00 AM
    clemsonfor replied to a thread New battery in Yanmar
    I bet they make about half the batteries on the market. There the biggest supplier I beleive. The other 2 are Interstate/Excide and Deka. Maybe...
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-13-2017, 11:53 AM
    clemsonfor replied to a thread New battery in Yanmar
    I had a legit 1 month old Panasonic, OE Toyota battery bought at the Dealer and installed by the dealer I bought my Highlander from go bad after a...
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-12-2017, 02:37 PM
    clemsonfor replied to a thread New battery in Yanmar
    The only true way to test a batteries charge or state of health is by taking a SG (specific gravity) reading when fully charged and 8 hours after...
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-12-2017, 02:36 PM
    clemsonfor replied to a thread New battery in Yanmar
    Yea my father in law use to sell and install AC Delco batteries at his shop. Those eyes were always green. I had 3 or 4 deep cycle Delco batteries....
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-11-2017, 10:21 PM
    clemsonfor replied to a thread New battery in Yanmar
    Batteries just go bad too. I had a battery, a panosonic go bad in a toyota. That's the original equipment brand for them. Just went out, it would...
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-11-2017, 10:18 PM
    clemsonfor replied to a thread New battery in Yanmar
    And you could of gone to walmart and got basically the same quality battery for $95. Three year free replacement and 7 year prorate. Seriously...
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-10-2017, 03:08 PM
    I honestly don't know. I bet the ones out toward us are that olastic, but the hydrants themselves are metal. There is a bunch of crud that comes...
    41 replies | 2323 view(s)
  • clemsonfor's Avatar
    11-10-2017, 01:35 PM
    With the FD we flush them to get all that rust and chunks out so we don't get it into our tanks and have metal find its way to a pump.
    41 replies | 2323 view(s)
  • clemsonfor's Avatar
    11-10-2017, 11:10 AM
    clemsonfor replied to a thread YM336D Overheating? in Yanmar
    I have 2 Samsung Galaxies!!! My own personal one and one for work !!!
    17 replies | 800 view(s)
  • clemsonfor's Avatar
    11-10-2017, 03:32 AM
    I was thinking you were suggesting to buy the commercial grade 3/4 hose. Those are pricy.
    41 replies | 2323 view(s)
  • clemsonfor's Avatar
    11-10-2017, 01:35 AM
    clemsonfor replied to a thread YM336D Overheating? in Yanmar
    These days unless I am at work, I do almost everything on my phone. It's what I have. I can pull it out in a second as I sit on the couch . Walk...
    17 replies | 800 view(s)
  • clemsonfor's Avatar
    11-09-2017, 11:28 PM
    For the cost of those two 3/4" hoses he could just cover the difference between the 1" pipe and 3/4" pipe and be done with it.
    41 replies | 2323 view(s)
  • clemsonfor's Avatar
    11-09-2017, 09:35 PM
    clemsonfor replied to a thread YM336D Overheating? in Yanmar
    It's there. Keep looking. All mine are posted from phone. It is tricky to find. I think its a little blue clink able link below the text box if I...
    17 replies | 800 view(s)
  • clemsonfor's Avatar
    11-08-2017, 10:50 PM
    clemsonfor replied to a thread Flat Proofing Who makes a good tire repair kit in Tires
    Safey seal is what most of the pros use. It comes in a red blow molded plastic case and has stainless handles on the reamer and plug tool, and uses...
    16 replies | 896 view(s)
  • clemsonfor's Avatar
    11-08-2017, 10:47 PM
    That's a pretty small tractor and the rear is not that big right? Even loaded it should not be that difficult. ..just keep it upright and don't let...
    8 replies | 3129 view(s)
  • clemsonfor's Avatar
    11-08-2017, 09:29 PM
    I have been buying Freestar tires from amain st205 75 15. Think the last 2 were $38 shipped to my door.
    22 replies | 3720 view(s)
  • clemsonfor's Avatar
    11-08-2017, 11:50 AM
    I would have long forgot to renew the posting . That's what always happens with me and CL especially on something like that that you know is not...
    35 replies | 7385 view(s)
  • clemsonfor's Avatar
    11-08-2017, 11:18 AM
    Im pretty sure that one does too. Like mine its variable on the YM2000. Its an hour at I think 2400rpm. so if you run half (1200rpm) that I guess it...
    35 replies | 7385 view(s)
  • clemsonfor's Avatar
    11-06-2017, 03:57 PM
    clemsonfor replied to a thread Installed new headlights in Yanmar
    Yea those headlights now are not very bright, like you said basically like an 1157 bulb. I keep saying I will do this, but I like the factory look...
    3 replies | 584 view(s)
  • clemsonfor's Avatar
    11-05-2017, 11:32 PM
    clemsonfor replied to a thread Installed new headlights in Yanmar
    Did you just install a wire mesh behind the holes and then bolt the lights to it?
    3 replies | 584 view(s)
  • clemsonfor's Avatar
    11-02-2017, 06:18 PM
    clemsonfor replied to a thread New battery in Yanmar
    Interstates have gone down hill. I had one go out in 3 years on my sequoia. This is the wife's daily driver. We have had it 3 years I guess now....
    28 replies | 1161 view(s)
  • clemsonfor's Avatar
    11-02-2017, 06:11 PM
    clemsonfor replied to a thread ZEN-NOH YM1500 in Yanmar
    Winston ideas are as good as any. These things self prime. Apparently this has happened before but this is the first I recall
    43 replies | 4885 view(s)
  • clemsonfor's Avatar
    10-29-2017, 01:50 PM
    clemsonfor replied to a thread Yanmar fluids in Yanmar
    Yes you can mix the gear oils , what's in there with what you bought. As for the GL 3,4,5 it's just new specs. There all backwards compatible. So old...
    10 replies | 711 view(s)
  • clemsonfor's Avatar
    10-27-2017, 01:49 PM
    I lifter the one off my ym2000 i too am average strength for my age. It is heavy but also it is liftable by hand. I lifted mine off as well. A hoist...
    22 replies | 1195 view(s)
  • clemsonfor's Avatar
    10-27-2017, 12:02 AM
    clemsonfor replied to a thread Tires/Wheels Options in Yanmar
    If your ok with keeping your ag tires or rice tires or even useing those turf tires like they make for the international cubs. Big tall skinny turf...
    3 replies | 452 view(s)
  • clemsonfor's Avatar
    10-24-2017, 03:52 PM
    clemsonfor replied to a thread My First Real Tractor! in Yanmar
    Mine bounces too. Do what we said. Unscrew it from the back of the tach. Clean ot and maybe lube with some graphite and put back on and just snug it...
    332 replies | 14209 view(s)
  • clemsonfor's Avatar
    10-24-2017, 01:12 PM
    Idiots!
    48 replies | 2918 view(s)
  • clemsonfor's Avatar
    10-24-2017, 07:37 AM
    clemsonfor replied to a thread My First Real Tractor! in Yanmar
    If your tach goes out Hoye is there for us. Parts for these old units are actually reasonable. With so many parts units around even the tach can...
    332 replies | 14209 view(s)
  • clemsonfor's Avatar
    10-23-2017, 09:50 PM
    clemsonfor replied to a thread My First Real Tractor! in Yanmar
    No reason to pull it all the way back. But when your cutting I bet you can have the petal all the way down and only be 2200 to 2400 when your...
    332 replies | 14209 view(s)
More Activity
About clemsonfor

Basic Information

About clemsonfor
Location (City, State):
Greenwood Co., SC
Occupation:
Forester
Real Name:
Nate
What Make/Model of Tractor Do You Own?:
Yanmar YM2000
Attachments:
Springtooth harrow, 4ft Box blade, 4ft Bush hoh, dirt scoop, LMC 12-16 disk harrow, boom pole
Hours:
150
Lot Size:
Home on less than 1 acre. 130 acres across the state.

Signature


YM2000. MF dirt scoop,4' Jbar bushhog,boompole, LMC 12-16 disk harrow, 4' Atlas boxblade (with rippers). 1980 chevy K10,1990 ford ranger 2wd (285K miles),1997 saturn SL2 (twin cam!!),2001Toyota Higlander
1986 Cobia 177 sunskiff w/1981 Johnson 60 hp
1991 Javalen 17ft w/same year 150 Johnson GT
Troybuilt 4 cycle & Echo 2 stroke,cold natured(need carb rebuild),MS390 Stihl, Northern tool pressure washer, mixes water into the oil in the pump(now dead, motor on a tiller). 5000 watt generator.

Statistics


Total Posts
Total Posts
8,508
Posts Per Day
2.84
General Information
Last Activity
Yesterday 09:45 PM
Join Date
09-11-2009
Referrals
0
© 2017 TractorByNet.com. TractorByNet is a registered trademark of IMC Digital Universe, Inc. Other trademarks on this page are the property of their respective owners.