Recent content by cpntexas

I hear ya, it's not so much the fuel gauge as I can ohm the sender leads and know the level, but it also affects the temp gauge and Id like to know of any issue as the prior owner got a hot issue and did not know till much later w/ steam, boil over and all. This tractor has to last!

Roadworthy, 12 volts under the conditions you specify. I do not have a schematic to determine so working from logic unfortunately. Temp gauge also acting the same..... Any idea where to physically locate that regulator you mention ? This sounds like a good trail to follow as the gauge acts...

Thanks to you both, just got the same tractor ['06] w/ loader and was maintained. With all the difficulty in finding good Montana info, bookmarking this info into my library. Any other sources of viable Montana info would be appreciated. Montana 4340 in Abilene Texas

'06 Montana 4340 having gas gauge issues - KEY ON Shows Constant Full Took out the Sender/float and measured a full swing from UP [full] position 10 ohms to 127 ohms full down [empty] Key OFF Tank 1/3rd full 5 of 16 gallons [spec] Gauge sits at E [expected] Sender disconnected - 2 wire reads...

Just got a '06 Montana 4340 to fix up at a great price, and looking for a reference or solution. The seat assembly has a new chair and slide, but find the entire seat's scissor suspension seems to "flop" all over the place. I have taken the entire assemble off the pan, as well as the seat/slide...